Begadi Fiber Sight for HiCapa Series
The Begadi Fiber Sights are specially built for TM HiCapa series, but if you fix them also fit on the WE or with careful adjustment also on KJW.
It can also happen that the holes on the front sight into which the rods are inserted are not quite suitable and have to be widened a bit
The optic rods are mounted as follows:
Heat the rod on one side very briefly with a lighter so that the end mushrooms a little. Now push the rod into the front sight and shorten it so that a small piece protrudes from the front sight.
Now heat the end again briefly with a lighter so that this also mushrooms and then holds the rod in position.
Features:
Scope of delivery: 1x front sight, 1x fiber rod in green and 1x fiber rod in red
Material: steel
Length of the front sight base: approx. 10.50mm
Width of the front sight base: bottom approx. 6.40mm, top approx. 5.40mm
Height of the grain base: approx. 1.65mm
It can also happen that the holes on the front sight into which the rods are inserted are not quite suitable and have to be widened a bit
The optic rods are mounted as follows:
Heat the rod on one side very briefly with a lighter so that the end mushrooms a little. Now push the rod into the front sight and shorten it so that a small piece protrudes from the front sight.
Now heat the end again briefly with a lighter so that this also mushrooms and then holds the rod in position.
Features:
Scope of delivery: 1x front sight, 1x fiber rod in green and 1x fiber rod in red
Material: steel
Length of the front sight base: approx. 10.50mm
Width of the front sight base: bottom approx. 6.40mm, top approx. 5.40mm
Height of the grain base: approx. 1.65mm
Review Partner